The SaluSpa hot tub has been a great addition to Ozuye. But there were some issues with the cover, and the floating air cushion inside.

When I arrived this time, the air cushion was filled with water instead of air. That makes it close to impossible to take it out (due to the water weight) and totally defeats the purpose of the air cushion.

So after getting all the water out and re-inflating the cushion, I discovered a puncture in the inner section. So I patched that and now the cushion is fully functional again.

For future reference; the outer section is not to be inflated, nor unplugged, as the cushion is just the right size with only the inner two sections inflated.

To avoid the cover blowing away, the cord to tighten it is now going under the connections to the pump and heater. To uncover, release the cord and flip the grey cover over to the side next to the pump. Then remove the black cushion and store it so that the wind doesn’t blow it away.

The pictures below illustrate the proper way to place both the air cushion and cover.

A hose that can be connected to the air pump is in the bottom right kitchen drawer. With a little effort it just fits the black air cushion.

the outer section of the air cushion is deflated and plugged

the cover fits the tub nicely once the tightener has been released.

The tightening cord stays under the connections to the pump to avoid it getting blown away by the wind.